The influence of humic acids on the phytoextraction of cadmium from soil

Cadmium poses a major environmental and human health threat because of its constant release through anthropogenic activities. A need, therefore, exists for cost-effective remediation procedures. Phytoremediation, the use of plants to extract contaminants from soils and groundwater, has revealed great potential. However, it is limited by the fact that plants need time, nutrient supply and, moreover, have a limited metal uptake capacity. Synthetic chelators have shown positive effects in enhancing heavy metal extraction through phytoremediation, but they have also revealed a vast number of negative side-effects. The objective of this research was to investigate the use of humic acids as an alternative to synthetic chelators. Humic acids were applied to a cadmium-contaminated soil at various dosages, and the uptake of cadmium into Nicotiana tabacum SR-1 was determined in relation to the amounts of total and bioavailable cadmium in the soil. It was found that the theoretical bioavailability of cadmium, as determined by diethylenetriaminepentaacetic acid (DTPA) extraction, did not change, but its plant uptake was enhanced significantly, in some cases up to 65%. Humic acids added at a rate of 2 g kg(-1) soil increased the cadmium concentration in the shoots from 30.9 to 39.9 mg kg(-1). A possible reason for this enhancement is the decrease in pH, resulting in higher cadmium availability. Another possibility taken into account is that plants may take up cadmium complexes with humic acid fragments, which result from microbiological degradation or, self-dissociation.     

Development of a accelerated solvent extraction and gel permeation chromatography analytical method for measuring persistent organohalogen compounds in adipose and organ tissue analysis

A new analytical method has been developed for the quantification of 59 different persistent organohalogen compounds, such as polybrominated diphenyl ethers (PBDEs), polychlorinated naphthalenes (PCNs), polychlorinated biphenyls (PCBs), PCB metabolites, organochlorine pesticides (OCPs) in biological organ tissues. The optimum extraction and cleanup procedures were examined using accelerated solvent extraction (ASE), automated gel permeation chromatography (GPC) on Biobeads S-X3 and automated solid phase extraction (SPE) on silica-gel. The target compounds were divided into two fractions, non-polar compounds and more polar compounds, which in the latter fraction was subsequently methylated using diazomethane. Detection can be achieved by GC/MS in negative chemical ionization (NCI) mode. The average recoveries of the compounds spiked in swine liver, heart, kidney, and cattle adipose tissues were considered satisfactory, and it was confirmed that the method could be used in routine analysis.     

Gestaltungsoptionen für handlungsf?hige Innovationssysteme zur erfolgreichen Substitution gef?hrlicher Stoffe (SubChem)

Ohne Zusammenfassung Online First: 27. 03. 2002 ‚Sustainable Substitution of Hazardous Substances‚; Projektbeschreibung unter wwwoekopolde oder wwwfh-hamburgdelpers/gleich_von bzw. www.uni-hamburgde/kooperationssteI1e-hh. Das Vorhaben wird vom Bundesministerium für Bildung und Forschung (BMBF) im F?rderschwerpunkt ‚Rahmenbedingungen für Innovationen zum nachhaitigen Wirtschaften’ (RIW) gef?rdert und von der GSF als Projekttr?ger betreut (FkZ. O7Riw4).     

Solute transport in crystalline rocks at Aspö--I: geological basis and model calibration

Water-conducting faults and fractures were studied in the granite-hosted Asp? Hard Rock Laboratory (SE Sweden). On a scale of decametres and larger, steeply dipping faults dominate and contain a variety of different fault rocks (mylonites, cataclasites, fault gouges). On a smaller scale, somewhat less regular fracture patterns were found. Conceptual models of the fault and fracture geometries and of the properties of rock types adjacent to fractures were derived and used as input for the modelling of in situ dipole tracer tests that were conducted in the framework of the Tracer Retention Understanding Experiment (TRUE-1) on a scale of metres. After the identification of all relevant transport and retardation processes, blind predictions of the breakthroughs of conservative to moderately sorbing tracers were calculated and then compared with the experimental data. This paper provides the geological basis and model calibration, while the predictive and inverse modelling work is the topic of the companion paper [J. Contam. Hydrol. 61 (2003) 175]. The TRUE-1 experimental volume is highly fractured and contains the same types of fault rocks and alterations as on the decametric scale. The experimental flow field was modelled on the basis of a 2D-streamtube formalism with an underlying homogeneous and isotropic transmissivity field. Tracer transport was modelled using the dual porosity medium approach, which is linked to the flow model by the flow porosity. Given the substantial pumping rates in the extraction borehole, the transport domain has a maximum width of a few centimetres only. It is concluded that both the uncertainty with regard to the length of individual fractures and the detailed geometry of the network along the flowpath between injection and extraction boreholes are not critical because flow is largely one-dimensional, whether through a single fracture or a network. Process identification and model calibration were based on a single uranine breakthrough (test PDT3), which clearly showed that matrix diffusion had to be included in the model even over the short experimental time scales, evidenced by a characteristic shape of the trailing edge of the breakthrough curve. Using the geological information and therefore considering limited matrix diffusion into a thin fault gouge horizon resulted in a good fit to the experiment. On the other hand, fresh granite was found not to interact noticeably with the tracers over the time scales of the experiments. While fracture-filling gouge materials are very efficient in retarding tracers over short periods of time (hours-days), their volume is very small and, with time progressing, retardation will be dominated by altered wall rock and, finally, by fresh granite. In such rocks, both porosity (and therefore the effective diffusion coefficient) and sorption K(d)s are more than one order of magnitude smaller compared to fault gouge, thus indicating that long-term retardation is expected to occur but to be less pronounced.     

Mineralization,metabolism and formation of non-extractable residues of 14C-labelled organic contaminants during pilot-scale composting of municipal biowaste

Use of municipal biowaste for composting instead of its disposal has become a major source of concern as regards contamination by hazardous substances. To elucidate the hazard potential of compost application, municipal biowaste was amended with 14C-labelled model substances (pyrene, simazine) and incubated in a pilot-scale composting simulation system. A mass balance incorporating the mineralization, metabolism and sorption of the two model substances was established over a period of 370 days. The results are quite different for the two chemicals, reflecting their intrinsic properties: more than 60% of the applied 14C-simazine resulted in non-extractable residues (NER). Silylation experiments indicated that the formation of NER from simazine and its metabolites was due to both physical entrapment in the matrix and chemical binding. The mineralization and formation of NER represented the major pathways of disappearance for pyrene during one year of composting, accounting for 60 and 26% of initially applied 14C-activity, respectively. Mineralization occurred delayed after the thermophilic phase. As regards remobilization, release of pyrene from NER during composting could be excluded, whereas simazine, data were inconclusive in this respect.     

Ozone pollution and ozone biomonitoring in European cities. Part I: Ozone concentrations and cumulative exposure indices at urban and suburban sites

In the frame of a European research project on air quality in urban agglomerations, data on ozone concentrations from 23 automated urban and suburban monitoring stations in 11 cities from seven countries were analysed and evaluated. Daily and summer mean and maximum concentrations were computed based on hourly mean values, and cumulative ozone exposure indices (Accumulated exposure Over a Threshold of 40 ppb (AOT40), AOT20) were calculated. The diurnal profiles showed a characteristic pattern in most city centres, with minimum values in the early morning hours, a strong rise during the morning, peak concentrations in the afternoon, and a decline during the night. The widest amplitudes between minimum and maximum values were found in central and southern European cities such as Düsseldorf, Verona, Klagenfurt, Lyon or Barcelona. In the northern European cities of Edinburgh and Copenhagen, by contrast, maximum values were lower and diurnal variation was much smaller. Based on ozone concentrations as well as on cumulative exposure indices, a clear north–south gradient in ozone pollution, with increasing levels from northern and northwestern sites to central and southern European sites, was observed. Only the Spanish cities did not fit this pattern; there, ozone levels were again lower than in central European cities, probably due to the direct influence of strong car traffic emissions. In general, ozone concentrations and cumulative exposure were significantly higher at suburban sites than at urban and traffic-exposed sites. When applying the newly established European Union (EU) Directive on ozone pollution in ambient air, it was demonstrated that the target value for the protection of human health was regularly surpassed at urban as well as suburban sites, particularly in cities in Austria, France, northern Italy and southern Germany. European target values and long-term objectives for the protection of vegetation expressed as AOT40 were also exceeded at many monitoring sites.